Paint Base
[Produktinnehåll]
Ståltank (Z2 Cap Specification / AP Airplane Cap Specifikation)
FRP Sidokåpa Vänster / Höger
FRP Tail Cowl
* Observera att det är nödvändigt att byta tanken med senstegs-tankledning och huvudbearbetningen vid montering av tanken.
* Vänligen använd bränslehane, bränslemätare sensorported STD (ZEPHYR 400 OEM).
* Emblemet säljs separat.
* Observera att följande föremål säljs separat.
Tank Emblem
Sidobildsemblem
Frontfender
Bakljus
* Det kräver bearbetning för baklampans installation.
* Det finns fall som det kräver bearbetning beroende på fordonet när du använder Z2-typ exteriörset för ZEPHYR 400 och X.
* Med avseende på bearbetningsplatsen
Vänligen stabilisera fixeringen av tankstyrningsgummiet genom att byta ut det för det sena skiktet av tankledargummi eller bearbeta på huvudkroppssidan när du monterar på fordonet i närheten av den ursprungliga typen av 400.
Svansen är endast fixerad på 2 punkter på framsidan (sittbotten). Därför rekommenderas att du använder stötstödet så mycket som möjligt bakom det, eftersom det kommer att leda till att bakdelen gradvis kommer ner och knäcker kringen.
paint basis
[Components]
・Steel tank (Z2 cap spec / AP airplane cap spec.)
・FRP side covers (right and left)
・FRP tail cowl
*When installing the tank, you will need to replace the tank guide rubber with the late model tank guide rubber and modify the body side.
*Please use the stock fuel cock and fuel gauge sensor of ZEPHYR400.
*Emblem sold separately
*The following items are sold separately.
・Tank emblem
・Side cover emblem
・Front fender
・Taillight
*Processing is required to install the tail lamp.
*When you use Z2 type exterior set for Zephyr 400 and x, modification may be required depending on the bike.
*About the processing part
・If you are using early model of 400, please replace the tank guide rubber with late model or modify the body to stabilize the fixation of the tank guide rubber.
・The tail cowl is fixed to the front side (under the seat) at two points only.Therefore, it is recommended to use the cowl with the support at the rear as much as possible, because the rear part of the cowl will gradually fall down and cause the cowl to crack.