- Passar:
- KAWASAKI Z1R-1 77-78 (all models)
- KAWASAKI Z750 77-78 D1 (Gibbon type)
- KAWASAKI KZ1000 77-78 A1/A2 (Gibbon type)
If you read the description, you will understand unless you are too stupid to understand.Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
Well, it's like this ….It's just right for Refresh for now!Läs mer - Passar:
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z1-R/Z1-RII 72-78
- KAWASAKI Z1 (900SUPER4) 72-78
- KAWASAKI Z1000 (air-cooled) 72-78
The raised edge prevents leakage.Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
I have often used Tie Wrap, but I had to cut it off and use a new one every time, so I bought it. I am glad I bought it, even though it seems rather expensive.Läs mer - Passar:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...och mer.
If you use it well, it will not leak oil as much as the OEM type rubber ones. if you degrease the BALI and apply the liquid gas well, and if you reuse it, you can use it almost permanently by removing...Läs mer - Passar:
- KAWASAKI Z900 (KZ900) 76-80
- KAWASAKI
- KAWASAKI Z750 (air-cooled) 76-80
- KAWASAKI Z1000 (air-cooled) 76-80
- KAWASAKI Z900 (KZ900) 76-80
- ...och mer.
Electric wiring on older cars should be replaced as much as possible, including the 6V MONKEY/GORILLA Main Harness, Regulator, BatteryLEAD, Blinker harness, and Tail lamp.You never know when or where ...Läs mer - Passar:
- KAWASAKI Z1000
- KAWASAKI Z1-R/Z1-RII 1
- KAWASAKI Z1000 (air-cooled) A2
- KAWASAKI Z1000 (air-cooled) A1
The Mounting Bolt hole did not fit and I had to cut about 1.5mm off the long hole side.The RegulatorBody is also very large, so I installed the Connector side upside down.It's in good working conditio...Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
Oil leak from Tachometer port is a common disease of air cooled Z.If it starts leaking, replace it with this one.The installation is a little hard, so apply more silicon grease and make sure to put it...Läs mer - Passar:
- KAWASAKI Z1000A 76-78
- KAWASAKI Z900 76-78
- KAWASAKI Z1 72-75
- KAWASAKI Z1R 1 Type
- KAWASAKI Z2 72-75
- ...och mer.
I bought the Coil, Rotor, One way clutch and Rose because the price is not so different from the OEM type. The installation was easier than expected because there is a video of the installation on PMC...Läs mer - Passar:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...och mer.
The Rear Sets and Kick pedal interfere with each other, so I removed the Kick pedal and installed this Cap.I like it because it matches the overall Image of the vehicle.It may not be suitable for a NO...Läs mer - Passar:
- KAWASAKI Z900 (KZ900)
- KAWASAKI Z750FX
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z1000 MkII
- KAWASAKI Z1000
- ...och mer.
There are not many used LTDOEMFender's available anymore.I think it is good to use it as it is if you can bear the texture of the plating.I couldn't stand it.Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
Purchased with Washer.Only Gasket is difficult to prevent from deteriorating.It is a necessity when replacing parts.To be honest, it would be a big help if you could stock only Gaskets by Manufacturer...Läs mer - Passar:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z1-R/Z1-RII
- KAWASAKI Z1000
- KAWASAKI Z1000 MkII
- KAWASAKI Z2 (750RS/Z750FOUR)
- ...och mer.
When reverting from Separate handle to STD Handlebar, the OEM Headlight BracketPurchased to re-install.If the cost was a little cheaper, I could be satisfied, but without this, the Light Bracket is ha...Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
This Nut is well thought out. If it is an aggregate tube, it is possible to fasten it even if it is different Nut somehow, but it is impossible if it is a 4-pipe exhaust system, and this Nut becomes n...Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
Before attaching the Meter Wire to the Meter, you must run the Clamp through the Wire or you will have to start over.I've done it.Läs mer - Passar:
- KAWASAKI Z1-R/Z1-RII 78-80
- KAWASAKI Z1-R/Z1-RII 78-80
- KAWASAKI Z1000 (air-cooled) 77-78
- KAWASAKI Z2 (750RS/Z750FOUR) 73-75
- KAWASAKI Z1 (900SUPER4) 72-75
- ...och mer.
If you want just the Washer, OEM Parts are still available.Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
OEM Parts are still available. The price is not so different. What is the quality of Rubber?Which one shall we choose?Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
OEM Parts are still available, so we recommend you to buy OEM Parts.Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
The material is made of cast iron, but I didn't want it to fall again, so I took it off immediately.Läs mer - Passar:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...och mer.
Oil leak & Ntilde. from Tachometer extraction part;It took me a long time to remove it, but I was able to remove it safely in the end. It took me a while to remove it, but I was able to remove it with...Läs mer
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING