- Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
If you install it bare, it will hit the bottom bolt protrusion of the Crankcase. This means that when you hit the GuardI'm about to split the Crankcase. I put a Spacer in the back Screw to float it.It...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
If you put it on as it is, it will hit the protruding threaded part at the bottom of the engine. In street drivingIt is not inconvenient, but AttackTouring, the person who uses it like hitting the bot...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
I installed it on my TL125.It arrived and I immediately removed the old Under Guard and installed it, but there was one problem.The bottom of the Crankcase hits the bulge of the Bolt. I tightened the ...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
I bought the Plate of Silver and installed it in TLR200.Not specifically mentioned in the description is the dish BoltQuantity:It looks like 2pc will be included.I think that I can say that both the f...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
This is a great skid plate. I would have given 5 stars if it hadn't needed some fitting and spacing to fit my bike. It needed 3/8" spacers at the rear and a thick 1/8"washer at the front. I would stil...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
Was pleased for first few days then noticed the stand was allowing bike to fall over. I added a small bolt to stop the stand from pivoting too far but after a few more weeks the stand just broke and I...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
I installed it in TL 125. Since installation is only attaching genuine engine guard and putting on it, it finished quickly without taking as much as 5 minutes of thing. I liked it, it is very cool and...Läs mer - Passar:
- HONDA TL125(TLR125) JD06
- HONDA TLR200 MD09
I installed it in TLR 200. Remove Front sprocket, replace, Rear also remove Tire, replace (A little overhead) Did. From Front 13 to 10 of OEMSprocket, Rear changed from 44 to 41. To travel on an ordin...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
Made of strong sturdy alloy plate 6mm thick.Alot wider than standard 250mm wide,protects gear change shaft.Change engine oil without taking skid plate off.Cut out slots allow more cooling air around e...Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125(TLR125) JD06
Nicely machined both axles only weigh 165gms much lighter than standard.Straight swap.Fine M12x1.00 threadLooks great. Läs mer - Passar:
- HONDA TLR200 MD09
- HONDA TL125 JD06
Since I just received it, I have not installed it, but the OEM Parts Number has been out of print, and when I was searching for other company's products on Wye Big, it was same as OEM Parts Number...Läs mer
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING